Mambohead

Okay, a few things left:

• get two small clamps for coolant plumbing (check)
• get large clamp for exhaust (15cm) (check)
• get 3 gallons of distilled water for coolant (check)
• get chemicals for acrylic welding (Methylene Chloride) (check)
• verify industrial cooler operation (check)
• finish quick vent design (check)
• cut out window vent parts (check)
• assemble vent (check)
• install vent (check)
• install and verify plumbing (exhaust, water cooling and compressed air) (check)
• solder high voltage wires (check)
• go over nuts and bolts of mechanical to make sure everything is good
• go over nuts and bolts of cabinet to make sure everything is good
• align laser (check)
• adjust mirrors (progress)
• go through focus procedure for first time
• figure out how to vector cut with software (raster is already done)
• cut! will be operational at this point if everything works!
• pick up corel in ogdensburg
• mount chiller, blower and compressor on a sound absorbing base to prevent drift and reduce noise

• ← Simpler Vent Design
• Thoughts about light →